Whether it is in a home, a workplace or anywhere else the use of metal work or any type of steel is hard to avoid. For high industrial workers this is a very serious problem when it comes to things like making buildings; vehicles like cars or airplanes or practically any other production that requires metal / steel. If corrosion was to be taken lightly the results could prove to be rater fatal. For example if engineers did not stop think about corrosive effects hen building a bridge, it could be highly unsafe or harmful for people.
Fortunately there are some steps we could take in order to prevent corrosion or at least slow it down for some time.
The galvanization of metals
This is basically the process of using a type of metal that is already coated in rarely corrosive metal like zinc. This creates a very protective surface on the metal preventing it from going through corrosion and rusting. One of the most common ways to do this is by hot – dip galvanization. This is when metal is put in zinc in a high temperature. This hot metal spray is rather hazardous and should always be handled by professionals.
Using blasting methods
This process is when specific materials are propelled towards metal using steamed, compressed air. This is a very effective method of preventing corroding of metal or steel and is used almost in every high industrial organizations. Materials used in abrasive blasting can vary from either roughly crushed glass grit, beads to even aluminum oxide. Just as this process could use to prevent rusting of metal, it could also be effective in removing rust from metal as well.
Application of lubricants
This could easily done by an individual at home and does not necessarily require a professional’s help. For flat metal surfaces, usually paint would act as a good layer of protection but paint would barely work if it is a piece of metal work that moves frequently. For frequently moving metal parts like window hinges or door hinges, paint would not work like said because the movement of the metal would cause the paint to crack and this would let moisture reach the metal. Because of this, for moving metal parts a water insoluble lubricant is one of the best and easily done techniques. But the lubricant might not last a life time and could easily wear out after months or years, so it requires frequent application in order to stop corrosion.